April 3, 2018
Be aware this does not fit an E3D hotend. The threaded length is too shallow to make contact with the heat break.
I do not fault the product for this issue, I just assumed it would work. See picture for difference, E3D on right side.
The finish and build quality of this product is good.
August 20, 2018
The bottom line is I am going to purchase again for 2 reasons. I had some issues with Luxnwatts parts which were not the merchants fault but he did correct the problem rapidly and to my satisfaction. Secondly, this is a large purchase and the product works correctly out of the box as per the installation instructions.
I used as Canadian merchant because i thought that increased my changes of getting any problems resolved if any appeared, sadly a couple did, the way my problems were resolved gives me enough confidence in the business owner that I can order with confidence again knowing i'll be taken care of if should the unexpected occur.
If you are a newbie as I am, heat the bed first and spray an even layer of scent free super hold hairspray on the bed and the print sticks to the printer bed just fine and prints great. Cleans up great after with window cleaner and paper towels.
Be aware of the properties of the materials (filament) you are printing with, it takes a while for the bed to heat up but the control box allows you to override the G-Code (learn about Cura) and pre-heat the bed before you print.
Also, by default in Cura this printer's Start up G-Code issues a command to drop the Z Axis down before printing15mm which will not print and also grind up your nozzle...sigh. Hope this helps someone.
So, Preferences, Configure Cura, Printers, Machine Settings, Start G-Code:
Change this line: G1 Z15.0 F6000 ;Move the platform down 15mm
To this Line: G1 Z0.0 F6000 ;Move the platform down 0mm
Using the control box, home, auto level on all 4 corners of the printer bed, home again, pre-heat, hairspray, you are ready to rock.
If you buy in Canada or even USA, this merchant is a safe bet.
April 19, 2018
The nozzles are probably A-1.
I will never know because I bought them for my FlashForge Finder (FlashForge is listed in the description of compatible products).
Turns out, they are too small.
Seller should specify which models, not which makes, but caveat emptor; buyer beware.
Check the specs on YOUR printer before purchasing replacement parts with broad (read 'vague') ranges of printers.
April 7, 2018
Bro don’t buy them if you have a V2 or Mini or Select Plus these are two small for that heating block, MK10 is the thread size you need, I know because I Bought these mk8 ETs for my printer and they were toooo small giving 5 stars because you know it isn’t all about me ! okay bye :)
March 6, 2018
As always item arrived fast, and the nozzles are great quality, work perfectly
August 28, 2018
Great Item! A++ Seller,good shipping, all is OK, Thanks!
September 11, 2018
Good product work great
April 9, 2018
Excellent product well packaged.